[0.10.22] Stuck trying to climb up over a specific ledge

Curated user bug reports with enough information to reproduce issue. Moderators will move topics here from Help & Support once a bug is confirmed and enough information has been provided.
Post Reply
User avatar
pango
Posts: 2321
Joined: Wed Jul 18, 2018 6:14 pm
Location: France
Contact:

[0.10.22] Stuck trying to climb up over a specific ledge

Post by pango » Sun Apr 26, 2020 7:31 am

While doing climbing tests, I noticed that I could get stuck trying to climb over a specific ledge.
This is not a regression, it has been around since at least 0.10.10 (didn't check with older versions).
Capture du 2020-04-26 09-31-52.jpg
Capture du 2020-04-26 09-31-52.jpg (49.82 KiB) Viewed 153 times
Attachments
SAVE631.zip
(188.93 KiB) Downloaded 5 times
When a measure becomes a target, it ceases to be a good measure.
-- Charles Goodhart

User avatar
pango
Posts: 2321
Joined: Wed Jul 18, 2018 6:14 pm
Location: France
Contact:

Re: [0.10.22] Stuck trying to climb up over a specific ledge

Post by pango » Sun Apr 26, 2020 7:38 am

It seems there's a faint gap in the model, I suspect that could be the cause
Capture du 2020-04-26 09-36-28.jpg
Capture du 2020-04-26 09-36-28.jpg (88.29 KiB) Viewed 151 times
When a measure becomes a target, it ceases to be a good measure.
-- Charles Goodhart

User avatar
Interkarma
Posts: 5472
Joined: Sun Mar 22, 2015 1:51 am

Re: [0.10.22] Stuck trying to climb up over a specific ledge

Post by Interkarma » Sun Apr 26, 2020 7:44 am

Thank you. Will look for a workaround when I can.

User avatar
pango
Posts: 2321
Joined: Wed Jul 18, 2018 6:14 pm
Location: France
Contact:

Re: [0.10.22] Stuck trying to climb up over a specific ledge

Post by pango » Fri May 22, 2020 9:51 pm

Actually I think that what we see on the screenshot above is not a gap, but a shadow.
The issue is that the top surface is protruding slightly
When a measure becomes a target, it ceases to be a good measure.
-- Charles Goodhart

User avatar
Interkarma
Posts: 5472
Joined: Sun Mar 22, 2015 1:51 am

Re: [0.10.22] Stuck trying to climb up over a specific ledge

Post by Interkarma » Fri May 22, 2020 10:18 pm

Yes, that's correct. I have looked at this one - the problem is basically the same as the case our unstick handler resolves except encountered vertically instead of horizontally. The player controller sticks to the protruding single sided geometry due to its implementation of physics.

I'm considering general solutions to this beyond just making another unstick handler for climbing as well. I've put it on the back burner for a while as much more to do.

Post Reply