While doing climbing tests, I noticed that I could get stuck trying to climb over a specific ledge.
This is not a regression, it has been around since at least 0.10.10 (didn't check with older versions).
[0.10.22] Stuck trying to climb up over a specific ledge [RESOLVED 0.10.25]
- pango
- Posts: 3359
- Joined: Wed Jul 18, 2018 6:14 pm
- Location: France
- Contact:
[0.10.22] Stuck trying to climb up over a specific ledge [RESOLVED 0.10.25]
- Attachments
-
- SAVE631.zip
- (188.93 KiB) Downloaded 130 times
Mastodon: @pango@fosstodon.org
When a measure becomes a target, it ceases to be a good measure.
-- Charles Goodhart
When a measure becomes a target, it ceases to be a good measure.
-- Charles Goodhart
- pango
- Posts: 3359
- Joined: Wed Jul 18, 2018 6:14 pm
- Location: France
- Contact:
Re: [0.10.22] Stuck trying to climb up over a specific ledge
It seems there's a faint gap in the model, I suspect that could be the cause
Mastodon: @pango@fosstodon.org
When a measure becomes a target, it ceases to be a good measure.
-- Charles Goodhart
When a measure becomes a target, it ceases to be a good measure.
-- Charles Goodhart
- Interkarma
- Posts: 7247
- Joined: Sun Mar 22, 2015 1:51 am
Re: [0.10.22] Stuck trying to climb up over a specific ledge
Thank you. Will look for a workaround when I can.
- pango
- Posts: 3359
- Joined: Wed Jul 18, 2018 6:14 pm
- Location: France
- Contact:
Re: [0.10.22] Stuck trying to climb up over a specific ledge
Actually I think that what we see on the screenshot above is not a gap, but a shadow.
The issue is that the top surface is protruding slightly
The issue is that the top surface is protruding slightly
Mastodon: @pango@fosstodon.org
When a measure becomes a target, it ceases to be a good measure.
-- Charles Goodhart
When a measure becomes a target, it ceases to be a good measure.
-- Charles Goodhart
- Interkarma
- Posts: 7247
- Joined: Sun Mar 22, 2015 1:51 am
Re: [0.10.22] Stuck trying to climb up over a specific ledge
Yes, that's correct. I have looked at this one - the problem is basically the same as the case our unstick handler resolves except encountered vertically instead of horizontally. The player controller sticks to the protruding single sided geometry due to its implementation of physics.
I'm considering general solutions to this beyond just making another unstick handler for climbing as well. I've put it on the back burner for a while as much more to do.
I'm considering general solutions to this beyond just making another unstick handler for climbing as well. I've put it on the back burner for a while as much more to do.
- pango
- Posts: 3359
- Joined: Wed Jul 18, 2018 6:14 pm
- Location: France
- Contact:
Re: [0.10.22] Stuck trying to climb up over a specific ledge
This is fixed in 0.10.25 (by switching to Unity 2019.4)
Mastodon: @pango@fosstodon.org
When a measure becomes a target, it ceases to be a good measure.
-- Charles Goodhart
When a measure becomes a target, it ceases to be a good measure.
-- Charles Goodhart